Dr Piyush Tailor

== Set Up The Lab For Instrument ==

1. Space for Instrument
2. Water Supply
3. Electricity Supply
4. Waste Maagement

== Installation Of Instrument ==

1. Get install Instrument by Its company person(Engineer).
2. Collect Installation Report.
3. Save This report in LIS under the menu 'Equipment Records'.

== Check Basic works Of Instrument ==

1. Simply start Maintenance for checking of all probes movements.
2. Check probes positions in all troughs(sample trough,reagent trough, stirrer troughs).
3. Check Up-Down movements of all Probes.
4. Check Movements of Cuvette Rinsing Unit(CRU) by giving Cuvette Ringe.

== Check Actual works Of Instrument ==

1. Set All the TESTS.
   • Calculate test cycles accordingly each tests and set reading periods.
   • Fill test parameters of each tests.
2. Do calibrations of each tests, calculate factor and enter for according tests.
3. IQC and LJ Chart.
   • Start doing IQC for each test, three times per day.
   • After collecting adequate IQC data, calculate mean(Target) and SD for each test. Set those targets and SDs in LJ.
   • Prepare LJ chart Daily.
4. Instrument Comparison
   • Run same samples for each tests in both the instruments, New Instrument (ERBA_XL_1000) and Current Instrunment (ERBA_XL_640).
   • Prepare excel sheet,Calculate Difference,Compare the results.
   • Draw Regression analysis chart, Bland-Altman Plot and do analysis of it.
   • Prepare acceptability Criteria.
   • And if needed, take action accordingly.
5. For EQC
   • Register new instrument in RIQAS Programme.
   • After Registration Done, Run current EQC sample, Prepare Excel Data Sheet.
   • Send the results to RIQAS on according Date.
   • Get the analysis report of our data from RIQAS.
   • Prepare monthly file based on RIQAS results.
   • Do analysis of this monthly file.
   • Take actions if needed.