 | Dr Piyush B. Tailor |
| Be Human - Be Part of Change |
*Home
*Lectures
- Model Questions
- Question Papers
- Social Media
- About
Sidebar
nchsls:c:biochemistry:document:installation_and_troubleshooting_of_zebra_tlp_2844_barcode_printer
How to install Zebra TLP2844
- open http://127.0.0.1:631/ .
- Click on “Administration” as shown in above screenshot and after clicking below screen appears.
- Click on “Find new printer” as shown in above screenshot and after clicking below screen appears.
- Click on “Add This Printer-Zebra TPL2844(Zebra TPL2844)” and after clicking below screen appears.
- Click on “Continue” as shown in above screenshot and after clicking below screen appears.
- Select “Zebra” and Click on “Continue” as shown in above screenshot and after clicking below screen appears.
- Select “Zebra EPL2 Label Printer(en)” and Click on “Add Printer” as shown in above screenshot and after clicking below screen appears.
- Select Media size “2.00×1.00”, resolution “203dpi” and Media Type “Thermal Transfer Media” then click on “Select Default Option” as shown in above screenshot.
- After installation print “Test page”( open http://127.0.0.1:631/–> Administration –> Manage Printer –> Print teast page.)
How to change Printer roll
- Open the barcode printer by pulling two side levers towards the front of the printer.
- Seperate and hold open the media hangers as shown in below image.
- Insert roll in between hangers and release the media hangers.
- Roll should pass through two black guides as shown in above image.
- Close the printer by pressing the coverlock inside as shown in image and tick sound will be heard when printer close.
How to change Ink roll
- Open the barcode printer by pulling two side levers towards the front of the printer.
Install the Ribbon Supply Roll
- Before following these steps, prepare the ribbon by removing its wrapping and pulling its adhesive strip free.
- Thread the ribbon through the carriage.
- Press the right side onto the supply hub.
- Align the notches on the left side and mount onto the spokes of the left hub.
Install the Take-Up Core
- Press the right side onto the take-up hub.
- Align the notches on the left side and mount onto the spokes of the left hub.
- You can find your first ribbon take-up core in the packing box. Subsequently,use the empty supply core to take up the next roll of ribbon.
Attach and Tighten the Ribbon
- You must align the ribbon so that it will be taken straight onto the core.
- Attach the ribbon to the take up core.Use the adhesive strip on new rolls;otherwise, use tape.
- Turn the ribbon take-up gear counter-clockwise (top moves toward rear) to remove slack from the ribbon.
- Close the top cover. Remember that you need to release the cover lock,lower the top cover, and press down until the latches snap into place.
- Close the printer by pressing the coverlock inside as shown in image and tick sound will be heard when printer close.
How To Calibrate printer manually
- First feed the Printer with printer roll.
- Press Feed button when restart printer.
- press continuously till printer calibrate and start printing paper
- after printing stop barcode paper print in last line——> Now in DUMP, press feed button to exit
- press Feed Button
What to do when one barcode get printed and another get troubled to print?
- remove connection pin of barcode from behind and reattached it manually. and then try to print barcode.
nchsls/c/biochemistry/document/installation_and_troubleshooting_of_zebra_tlp_2844_barcode_printer.txt · Last modified: 2022/08/13 07:34 (external edit)
