Dr Piyush Tailor

1. 1.open http://127.0.0.1:631/ .
2. 2.
3. 3.Click on “Administration” as shown in above screenshot and after clicking below screen appears.
4. 4.
5. 5.Click on “Find new printer” as shown in above screenshot and after clicking below screen appears.
6. 6.
7. 
8. Click on “Add This Printer-TSCP200)” and after clicking below screen appears.
9. 
10. 
11. 
13. Select Media size “2.00×1.00”, resolution “203dpi” and Media Type “Thermal Transfer Media” then click on “Select Default Option” as shown in above screenshot.
14. After installation print “Test page”( open http://127.0.0.1:631/–> Administration –> Manage Printer –> Print teast page.)

1. open the barcode printer by pushing the two side levers placed on the sides of the printer.

2.This is what it looks like after the cover(lid) gets opened.

3.

4. Attach the white roll in between the hanger.

5.

6. The white roll should get through these three pointers.

7. This is how the black roll printer is being adjusted.

8. …..

9. The black roll should be inserted on the this black stick.

10.This is how black roll looks like from outside.

11. The shiny part goes in, the rough part comes out.

12. Be careful to open the lid containing the black roll. This green colored “push” button needs to pushed inward inorder to open this lid.

13. Thus the lid closes and through the LIS printed barcode can be now be generated.

14.Close the printer by pressing the coverlock inside as shown in image and tick sound will be heard when printer close.

SUMMARY

How to change Printer roll

  Open the barcode printer by pushing two side levers towards the inner side of the printer.
  Seperate and hold open the media hangers as shown in above image 1. and 2.
  Insert roll in between hangers as in 3., 4., and 5.
  Roll should pass through the points as in image 6.
  

How to change Ink roll

  For changing the black roll kindly see images 7., 8. and 9. 

Refer to image 10. for cross checking the black roll how it looks from outside. And in image 11. the shiny part goes in , the rough part comes out.

Attach and Tighten the Ribbon

  The ribbon must be aligned so that it will be taken straight onto the core.
  Attach the ribbon to the take up core.Use the adhesive strip on new rolls;otherwise, use tape.
  Turn the ribbon take-up gear counter-clockwise (top moves toward rear) to remove slack from the ribbon.
  Close the top cover. Remember that you need to release the cover lock,lower the top cover, and press down until the latches snap into place.
  Close the printer by pressing the coverlock inside as shown in image and tick sound will be heard when printer close.