====**Procedure For Instrument Acceptibiliy**====


__// == Set Up The Lab For Instrument ==//__
  - Space for Instrument 
  - Water Supply 
  - Electricity Supply
  - Waste Maagement 



__// == Installation Of Instrument ==//__
  - Get install Instrument by Its company person(Engineer).
  - Collect Installation Report.
  - Save This report in LIS under the menu 'Equipment Records'.

__// == Check Basic works Of Instrument ==//__
  - Simply start Maintenance for checking of all probes movements.
  - Check probes positions in all troughs(sample trough,reagent trough, stirrer troughs).
  - Check Up-Down movements of all Probes.
  - Check Movements of Cuvette Rinsing Unit(CRU) by giving Cuvette Ringe.

__// == Check Actual works Of Instrument ==//__
  - Set All the TESTS.
      * Calculate test cycles accordingly each tests and set reading periods. 
      * Fill test parameters of each tests.
  - Do calibrations of each tests, calculate factor and enter for according tests.
  - IQC and LJ Chart.
      * Start doing IQC for each test, three times per day.
      * After collecting adequate IQC data, calculate mean(Target) and SD for each test. Set those targets and SDs in LJ.
      * Prepare LJ chart Daily.
  - Instrument Comparison
      * Run same samples for each tests in both the instruments, New Instrument (ERBA_XL_1000) and Current Instrunment (ERBA_XL_640).
      * Prepare excel sheet,Calculate Difference,Compare the results.
      * Draw Regression analysis chart, Bland-Altman Plot and do analysis of it.
      * Prepare acceptability Criteria.
      * And if needed, take action accordingly.
  - For EQC
      * Register new instrument in RIQAS Programme.
      * After Registration Done, Run current EQC sample, Prepare Excel Data Sheet.
      * Send the results to RIQAS on according Date.
      * Get the analysis report of our data from RIQAS. 
      * Prepare monthly file based on RIQAS results.
      * Do analysis of this monthly file.
      * Take actions if needed.